2 Rectangular Plane Processing The system offers rectangular (Page 42 / 87) CNC nk105

EasyRoute Control Panel is based on Weihong NK105 CNC Integrated Machine OEM http://am.co.za/router/panel

上海维宏电子科技股份有限公司

Weihong Electronic Technology Co., Ltd.

7.3.2. Rectangular Plane Processing

The system offers rectangular plane processing; after setting parameters successfully, press

“Up” or “Down” key to select [Load Now] and then press [OK] to load the processing file; and then you

can press

to start machining.

Or select “2. Load the Last”, and then press [OK] key for confirmation and return to processing

page; and then press

to start machining.

Parameters of “X Init” and “Y Init” decide the initial position of processing plane; “Height” and

“Width” decides the size of processing plane; two kinds of processing mode are available: “Horiz. Mill”

(the feed direction of tool is parallel to X axis) and “Long. Mill” (the feed direction of tool is parallel to Y

axis); “Each Dpth” is the tool processing depth each time; generally, the value of “Engr Dpth” (the total

depth of several millings) is set bigger than that of “Each Dpth”; if the value of “Each Dpth” is equal to

or bigger than that of “Engr Dpth”, only one milling will finish processing; “Nose Gap” means the

distance between two adjacent lines, whose value should be set smaller than that of Tool Dia” to

avoid missing milling.

Note:

1. When the parameter settings are finished and “Load Now” is selected, you still need to press [OK] key to load

the processing file.

2. If the input value of “Engr Dpth” is too big, the system will send the warning information “Too many file layers

generated, continue?”, as shown in Fig. 7-6. You can press [ESC] to back to modify the value; or press [OK] to

load the file forcibly, the system staying in the interface shown in Fig. 7-6. At this time, if you press a key, its

function will not be executed until this dialog box disappears, so it is not allowed to press any key under this state.

You can wait patiently until the file is loaded, or you can power off and re-power on the system.

Too many file

layers generated

ESC

7.3.3.

Fig. 7-6 Warning dialog when parameter not properly set

Select Line No.

This interface shows the loaded file information, like total line, start line No. and end line No. The

default setting of “Start Line” is the breakpoint position of current file, and “End Line” the last line. With

Specialized, Concentrated, Focused