92 VICSION VS500
8.3 Reset
Be sure to check the fault cause and exclude it before reset, otherwise, which may lead to
the inverter, permanent damaged.
If the inverter can not be reset or occur the fault again after reset, please find out the
reason. Continuous reset will damage the inverter
Over-load or over-heat protective action should delay 5 minutes to reset.
When the inverter occurs the fault, you can reset the inverter to resume the normal running by any way as
follows:
I. External reset input-terminal RST and GND terminal are closed, and then off.
II. While the fault code is displayed, press
key.
III. It will send fault reset instrument by RS485 interface.
IV. Turn the power source off.
VS500 series of general purpose inverter Duxe.ru
    "