F506 Ratio grain Setting range 00~100 F507 Integral (Page 79 / 112) Simphoenix E500 Series Universal Low-Power Inverter User Manual

70 Function Parameter Table

F5.06 Ratio grain

Setting range: 0.0~10.0

F5.07 Integral time

Setting range: 0.01~10.00Sec

It iFs5p.0a8rameDteerrigvraotiuvpe otifminener PID controlled. Setting range: 0.00~10.00Sec

F5.09 PID adjustment frequency range Setting range: 0 ~ 100%

This parameter is used to set the upper limit frequency to be a adjusted by PID,

which is the percentage of maximum output frequency corresponding to the

maximum PID value.

F5.10 Breakage detection lower limiting value Setting range: 0.0 ~50.0%

F5.11 Breakage detection delay time

Setting range: 0.1 ~10.0Sec

If the system’s feedback value is less than the breakage detection lower limiting

value, it is deemed that the system is at the break ge status and the system starts

detecting breakage. After the delay time, if the system is still at the breakage

status, then it is deemed that there is a breakage fault.

6.7 Special machine parameter group

F6.00 Cutting function selection

Setting range: 0000~0001H

This parameter is used to select if this inverter is used for cutter dragging or

cutting control.

0: As the dragging control

1: As the cutting control

F6.01

F6.02

Cutting length

Correction of liner speed coefficient

Setting range: 0.01~10.00

This group of parameters is effective for cutting control. The cutting length is the

set value of required wood length in the unit of meter. [F6.02] parameter is used

for length correction which will be done according to mechanical characteristics.

E500 Series Universal Low-Power Inverter