1.4 servo driver installation
1.3 product front panel
1.4.1 The environmental conditions for installation
Since the environment conditions for servo driver installation have the direct influence to the normal function
and service life of the servo driver, therefore the environment conditions must be conformed to the following
conditions:
z Ambient temperature: 0 to 40℃; ambient humidity: less than 80% (no dew).
z Storage temperature: -40 to 50℃; Storage humidity: less than 93% (no dew).
z Vibration: less than 0.5G.
z Preventive measure shall be taken against raindrop or moist environment.
z Avoid direct sunlight.
z Preventive measure shall be taken against corrosion by oil mist and salinity.
z Free from corrosive liquid and gas.
z Preventive measure shall be taken against entering the servo driver by dust, cotton fiber and metal tiny
particle.
z Keep away from radioactive and inflammable substances.
z When several driver installments in a control cubicle, for good ventilation please reserve enough space
around each driver, install fans to provide effective cooling, keep less than 40℃ for long-term trouble-free
service.
z If there are vibration sources nearby (punch press for example) and no way to avoid it, please use absorber
or antivibration rubber filling piece.
z If there is disturbance from interferential equipment nearby along the wirings to the servo driver can make
the servo driver misoperation. Using noise filters as well as other antijamming measure guarantee normal
work of the servo driver. However, the noise filter can increase current leakage, therefore should install an
insulating transformer in the input terminals of power supply.
1.4.2 The method of installation
z In order to get good cooling the servo driver should normally mount in vertical direction with the topside
upward.
z For installing the servo driver, fasten the backboard of the servo driver with M5 screw bolt.
z Reserve enough space around the servo drivers as shown in the reference diagram. In order to guarantee the
performance of the servo driver and the lifetime, please make the space as full as possible.
z To provide vertical wind to the heat sink of the servo driver should install ventilating fans in the control
cubicle.
z Prevent the dust or the iron filings entering the servo driver when install the control cubicle.
3
