HSD
The tool-holder is not
locked:
The tool-holder is not
expelled:
Lack of pressurisation:
One of the sensors does
not provide the required
output:
Foreign body between tool- Remove the foreign matter and
holder and spindle shaft:
clean as described in section 7
The tool-holder cone is not of Choose a tool holder according to
the required type:
the indications in paragraph 6.6
Check the required pressure
values indicated in paragraph
The collet does not open due to 4.4
lack of pressure:
Check the integrity and
efficiency of the pneumatic
circuit.
Sensor S2 is disconnected or
faulty:
Check the connectors;
Check the integrity and
continuity of the electrical
connectors;
Carry out the adjustment of
the sensor as described in
paragraph 8.8
If necessary, replace the
faulty sensor as described in
paragraph 8.8
Insufficient pressure:
Insufficient pressure or
inefficient pneumatic circuit:
Sensor disconnected or faulty:
Check the required pressure
values indicated in paragraph
4.4
Check the integrity and
efficiency of the pneumatic
circuit.
Check the required pressure
values indicated in paragraph
4.4
Check the integrity and
efficiency of the pneumatic
circuit;
Contact HSD Customer
Service.
Check the connectors;
Check the integrity and
continuity of the electrical
connectors;
Carry out the adjustment of
the sensor as described in
paragraph 8.8
Replace the sensor as
described in paragraph 8.8
5801H0056 ______________________________________________________________ 177/183
    "