Page 34 of 47

LFS-PM-T43 Live Focus System Operating Manual V1.3
1.3 Cutting Test
Before start a cutting, user should configure the parameters of the machine correctly. please
reference to the RDC6332M controller operating manual.
Cutting test should follow the steps:
1) Open MetalCut, draw a cutting rectangle with the drawing tools.
2) Set the layer parameter
For laser piercing, the motion controller support CW piercing and pulse piercing mode. To set the
piercing mode in the user parameters and layer parameters.
The piercing time is decided by the piercing times (n) and single piercing time (Ton).
Piercing time = n*Ton
If laser CW piercing has been enabled, there is a continuous laser on the metal work piece for a
certain time and then start a normal cutting.
Pulse piercing is used to be applied for thick metal sheet cutting.
The following is a example for pulse piercing. The piercing times are 4 and the single piercing time is
Ton. The interval time between 2 pulse is Toff.
SHENZHEN RUIDA TECHNOLOGY
27
    "