layer) in general. ② The scanning interval is set above 0.1mm for bitmap layer (BMP
layer) in general, and then the Minimum power and Maximum power should be changed
to attain the perfect effect of the scanned figures.
4.10.3 Laser Cut Parameters Setting
Seal cutting has not closed the
graphics appear the case is closed,
you can compensate with the seal to
close, but if the seal is misplaced, you
can not compensate, you can use
4.9.5
optimization
backlash
compensation to compensate, or to
Open delay
Close delay
Using the slit width compensation can compensate for the offset between the
graphics and the actual output graphics that caused by laser cutting.
It only has effective for the closed graph.
Direction: Compensation direction is set according to actual needs, such as cutting a
circle, if you want to retain the cutting down of the circle, you should set out the direction of
compensation; If you want to keep the hole should be set to compensate for the inward
direction.
Sew width: it is the width of the laser.
