max. speed of the X-axis and that of the Y-axis, if the setting is illegal, the controller will
automatically set this parameter within the range above; a comparatively high idling speed
can shorten the operation time of the entire figure while excessively high idling speed may
cause dithering of the tracks, therefore, you should take all relevant factors into
consideration when setting.
Idle Acc: Corresponds to the acceleration of the speed of air travel time, air and
air-way-way speed of acceleration to match, if you set too slow the actual speed may not
reach the air-way set value, if set too fast, they may not withstand the mechanical
structure, resulting jitter . Slightly higher than the general acceleration of air-way cut
acceleration.
Cutting Acc: Corresponding to the acceleration of the speed of cutting (cutting speed
is the speed of the layer parameters of the layers).
Turning speed: Turning the corresponding deceleration in the cutting process, the
minimum speed of the drop, when processing a lot of teeth when the graphics may be
appropriate to reduce the turning speed.
Turning Acc: Should match with the turning velocity.
Cutting mode: Split precision cutting, fast cutting, ultra-fast cutting, the user can
choose according to the actual applications. Such as the emphasis on accuracy, select
the precision cutting, such as emphasizing speed, select the fast cutting.
Acce. mode: this parameter decides the acceleration and deceleration mode (S
mode or T mode) of the motor during operation, the motor accelerates and decelerates
slowly and smoothly in the S mode and fast and relatively unsmooth in the T mode; the
default mode is the S mode.
3.3.2 Sweep parameters
x Start Speed, y Start Speed: Off scanning speed in the use of stepper motor drag,
do not began to accelerate from 0, but can start work directly from a speed to shorten the
overall processing time, but the speed is not too high, and because the X, Y axial load is
different from the rate, general the initial speed of X-axis slightly higher than the initial
speed of Y-axis
x Acc, y Acc: With the scanning speed (the speed of layers in the layer parameters)
to match, if set too small, the scan speed to a longer distance, the scanning efficiency. The
machine can be set according to the actual structure, load conditions vary. Since X, Y axis
load, generally much higher than the X-axis Y-axis accelerometer.
Line shift speed of scanning: this parameter is specially used to control the max.
