3. "Fast mode": tick refers to the match object in the counter clockwise
rotation of 20 degrees clockwise rotated 20 degrees between the angle range
can match, while more than the angle range of object did not match the
success. General point of view control in the range of 20 to match the speed
will be faster, no tick refers to the maximum rotation angle between the
matching object and template. Matching objects in inverse clockwise rotation
of 180 degrees clockwise rotated 20 degrees between the angle range can
match in matching speed will be low.
All the template parameters: all the parameters in the range apply to the
template that was checked in all the template lists.
4 "positive and negative 180": when the graph is rotated 180 degrees when
the speed matching
5 "smoothing coefficient": refers to the template after the definition of template
characteristics of the filter parameters. The more template features, the lower
the matching efficiency, so it is necessary to filter out some of the template
features. Under normal circumstances is 50~70, if the template features more
and more miscellaneous, this time it is necessary to improve the smooth
coefficient. Drag the slider to adjust the size of the 10 integer times, but also
can be manually input any integer value.
6 "overlap": refers to the need to be matched to the need to cut the template contour data
and the surrounding area has been cutting the material overlap area ratio,
the following figure 2 object and 1 object will need to set up 100% of the
overlap ratio, otherwise the object will not be cut 2. This parameter is to
prevent the object that has been cut to bad.
Selection process template:
46
