Page 43 of 49

Service Support Spirit
1. Check whether collision signal can work
normally(check whether proximity switch or
When auto IHS
torch retaining cap can reflect the collision
work, torch is THC do not receive
situation normally). If it can not reflect the
11. not uplifted collision signal or IHS
collision situation normally, IHS will not be
after it collide height is too small.
accomplished. 2. Check whether positioning
steel plate.
height time setting is too small, if this setting
value is too small, gun will not be uplifted.
Torch is easy
Increasing the arc voltage setting point
to collide steel Arc voltage setting is
12.
plate during too small
torch work
During auto
Reducing the sensitivity coefficient P07
height control The sensitivity is too slightly
13.
work, torch is high
easy to vibrate
When touch
1. Increasing sensitivity coefficient P07
work in the
slightly 2. Changing lifting motor which has
relatively steep The sensitivity is too faster speed
14. slope, arc small, or lifting motor
voltage follow speed is too small
speed is too
small
After plasm arc CNC can receive arc feedback signal which
breaking
has make by plasma
Arc breaking is happened,
arc
happened
voltage do not
during torch decline right away.
15. work, CNC do After THC receive this
not make torch signal, it think arc
stop work right start is working
away
normally, and do not
send arc breaking
signal
Unique Solution
WWW.ARCBRO.COM
43
    "