HYD
深圳市宏宇达数控技术有限公司
2、XPTHC-100Ⅲ commission and set
2.1 Operation panel intro
Dynamic pierce
IHS
Set arc
height set Height set
Pierce delay set Up
Arc display arc on test Dynamic pier test IHS test Man/auto
down power
Figure 2-1 operation panel
Arc Voltage
Before Arc Start it shows the Set Arc Voltage, after it shows the Actual Arc Voltage.
ARC-VOLTAGE SETTING
Based on the thickness of steel plate being cut and cutting speed, it shall be set
according to the parameter offered by Plasma, and it will be showed on operation
panel. Set Arc Voltage decides the Torch Height during cut, the higher the arc is, the
higher the Torch Height will be. On Auto mode, adjust the Set Voltage means
adjusting the Torch Height.
Pierce HEIGHT
Increase on clock-wise turn, decrease on anti-clockwise. Pierce height means torch
lift up height after receiving dynamic pierce signal from plasma or arc feedback signal
from plasma. It is used on cutting thick material. If the dynamic pierce signal is
disconnected, this function is disabled.
IHS HEIGHT
Set Initial Height, turn clockwise, the height increases.
PIERCING DELAY
地址：深圳市南山区中山园路 100 号 E4-6C(TCL 国际 E 城)
- 7 -
TEL：755-26625800 FAX：755-26729960
