Page 30 of 31
BWT20 Qilin Wobble Handheld Laser Welding Head
Precautions for using a laser welding system
1. Laser welding machine includes laser source, chiller, laser welding system, laser welding
head multiple control modules. In order to avoid interference, to ensure that the argon
arc welding machine and related equipment with large interference, to ensure a safe
distance of more than 5 meters.Ensure that the laser welding machine has independent
space when conditions permit.
2. In order to reduce the equipment leakage or static electricity, to ensure that the light
double pendulum industrial welding head equipment uses effective ground wire.
3. Please repeatedly confirm whether the sleeve joint is normally connected and locked,
which can be wrapped with insulation tape.
4. Check whether the laser head and the optical fiber are locked and connected. After
confirming the normal condition, use the tape tape to ensure that the dust does not
enter the laser head cavity.
5. Check whether there is water seepage in the cavity. There are many waterways in the
cavity. The screws should not be loosened without professional training to prevent water
droplets from entering the cavity.
6. Check whether the protective lens drawer is normal, ensure that the sealing ring is
normal and effective, ensure that the protective lens wipes the external stains of the
laser lens, at least 5 times, and ensure that the lens environment is dust and wind.
7. The laser head is complex. To avoid short circuit, stay away from the water source and
ensure that no liquid can be sprayed on the laser head.
8. Laser head refuse to use strong wind to blow and clean the laser head, can only use
alcohol and dust-free cloth to wipe.
9. A digital motor is installed inside the laser head, which must be taken and put gently
when used to prevent motor failure.
10. If the laser head is not used, please use the system gas for many times to discharge the
dust, remove the copper nozzle, seal with sealant belt, and install the copper nozzle to
blow gas more than 2 times before use.
11. Continuous interruption of power supply will cause damage to the welding control system.
Shenzhen Qilin Laser Application Technology Co., Ltd.
