7.2.3【送丝参数】:用于设置送丝参数,包括补丝参数、退丝参数等。
退丝速度: 松开启动开关后电机退丝的速度。
退丝时间: 电机退丝的时间。
补丝速度: 电机补丝的速度。
补丝时间: 电机补丝的时间。
送丝延迟时间: 出光后延迟一段时间再送丝,一般为0
连续送丝: 用于送丝机换丝,单击一次可持续送丝,再次单击后停止。
连续退丝: 用于送丝机换丝,单击一次可持续退丝,再次单击后停止。
Wire feeding parameter: used to set parameters related to wire feeding, wire supplement and withdrawal.
Wire withdrawal speed: the wire withdrawal speed of motor when the start button is loosened.
Wire withdrawal time: the time for motor wire withdrawal
Wire supplement speed: the speed of motor wire supplement
Wire supplement time: the time for motor wire supplement
Wire feeding delay time: wire feeding after light delay for a period, generally it’s 0.
click again to stop it.
Continuous wire feeding: used to change wire for the wire feeder. Click once for continuous wire feeding,
Continuous wire withdrawal: used to change wire for the wire feeder. Click once for continuous wire
withdrawal, click again to stop it.
【诊断】 :用于监测当前系统的IO 状态。
7.2.4【设备参数】 :用于设置设备相关参数。
激光器额定功率:用于设置激光器的额定功率。
振镜最大偏角:用于设置振镜最大偏角范围。
最大激光频率:设置激光器 PWM 信号的最大频率,当焊接参数设置的
PWM 频率超过 最大频率时,PWM 频率会被限制到最大频率。
最大摆动长度:设置摆动时的最大长度,当焊接参数设置的长度超过最大的长度时,长
度会被限制到最大长度。
送丝步距: 电机送丝时的步距。
送丝电机方向: 设置电机送丝的方向极性。
振镜矫正系数:当设置的长度与实际的长度不一致,存在微小差别时,可以通过该参数
    "