Error E1: Short Circuit Error
If errors persist without connecting any attachment, the Control Unit has Short Circuit,
and needs to be replaced.
If error E1 after connecting an attachment, cause might be:
o Heating element short circuit (need to replace)
o Wrong wiring, might be temperature sensor presented (likely, if not our attachment)
Error E2: Open Circuit Error
No attachment connected, connect an attachment.
If an attachment connected, causes might be:
o the heating element inside might be burnt (check continuity to make sure)
o Wrong wiring, no close loop present (likely, if not our attachment)
Error E3: Thermal Sensor Init Error
The Control Unit damaged, needs to be replaced.
----------------------------------
SKU for Spare Parts:
H-CONTROL
H-PRESS/CAP
H-PRESS/CUP350
H-PRESS/CUP500
H-PRESS/DISK12
H-PRESS/DISK15
H-PRESS/FLAT
H-PRESS/FLAT/E
H-PRESS/MUG240
H-PRESS/MUG320
Heatware Heat Press Control Unit with Temperature & Timer Controller
Heatware Heat Press Caps, Hats & Beanies Heating Pad
Heat Press 350ml Cone Shaped Cups Heading Pad Attachment
Heat Press 500ml Cone Shaped Cups Heading Pad Attachment
Heatware Heat Press Φ120mm+ Round Disk Heating Pad
Heatware Heat Press Φ150mm+ Round Disk Heating Pad
Heatware Heat Press 290×380mm Flat Heating Board Attachment
Heatware Heat Press 380×380mm Flat Heating Board Attachment
Heatware Heat Press 240ml Cylinder Mugs Heading Pad Attachment
Heatware Heat Press 320ml Cylinder Mugs Heading Pad Attachment, with
Connector
H-MAT/2938
H-MAT/3838
H-PRESS/ARM
H-PRESS/ARM/E
H-PRESS/CUP
H-PRESS/HANDLE
Silicone Foam Rubber Mat, 290×380mm Size and 8mm Thickness (Blue)
Silicone Foam Rubber Mat, 380×380mm Size and 10mm Thickness (Brown)
Heatware Multitalent Heat Press Extension Arm with Column Housing
Heatware Multitalent Heat Press Extension Arm with Column Housing for 3838
Heat Press Unit
Heatware Heat Press Cup and Mug Press and Lock Stand
Heatware Multitalent Heat Press Handwheel with Crank Handle, Shank 10mm,
Diameter 80mm
    "