Printing Step Alignment This alignment is only required (Page 4 / 5) FastCOLOUR EPSON Printhead Alignment Tool User Guide

http://www.LargeFormatPrinter.co.za/

Printing Step Alignment

This alignment is only required to be performed when machine has been setup first time, or after

motor, belt, gear, any mechanical has been changed and/or any printed circuit board has been

change.

 Tune Method

Press “Tune” T Button, your printer will print two crossed lines with numbers underneath.

…… +8

-2

-4

-6

-8 ……

The goal is to get two lines crossed at position 0.

If two lines crossed but position is not 0, type the number underneath crossed point into block D ,

then Calculate U and Save E , then print again.

If two lines NOT cross, use “Step Align” method below. Then perform “Tune” again for best result.

 Step Align Method

Press “Step Align” S Button, your printer will print a big square. Once finished printing, measure the

Length (the media rolling direction, not width) of the square, and put the measurement in millimetre

(mm) into Block B , then calculate L and save E .

Then back to “Tune” to get best result of step alignment.