图 3.5 抱闸电机接线图
Figure3.5 Wiring Diagram for Band-type Brake Motor
伺 服 电 机 Servo motor
抱 闸 线 圈 Band-type brake coil
DC12V 到 DC24V 开 关 量 信 号 电 源 Power supply for DC12V-DC24V switching value signal
KA 继电器 KA relay
DO-1000 伺 服 驱 动器 DO-1000 servo driver
制动电源 DC12V 到 DC24V
Pin No.
1
2
3
Pin mark
DC+
DC-
PE
DC12V- DC24V braking power supply
Function Description
DC power supply positive pole DC24V+
DC power supply negative pole 0V
Housing ground wire
Table 3.1 Socket for Servo Motor Band-type Brake
● It is required that the band-type brake braking power supply should be separated from the
upper computer and the DC power supply of the driver to prevent interference.
● The braking power supply for the band-type brake has positive and negative poles, which
should not be connected reversely to prevent short circuit.
● In order to improve braking effect and response, a fly-wheel diode may be added at both ends
of the braking coil(pay attention to the positive and negative poles of the diode).
25
    "