Page 16 of 49

4. Basic Operations
4.1 Pressure Test
It will help you to know the conditions of the blade.
Press the
or
button, Appliance will cut a rectangle which shown as above,
Check if the rectangle can be completely teared off or not in order to make sure the right
pressure and the length of the blade tip
NOTE: When the cutter blade is worn and dull, you can use it temporarily by
enhancing the value of PRESSURE. However, you are recommended to
replace the worn cutter blade with a new one to ensure a satisfactory cutting
quality.
4.2 Pressure and Speed
(1) Press
or
button goes to the interface
which F100 is pressure，V500 is speed.
(2)
Pressure
or
Decrease the pressure
or
Increase the pressure
Speed
or
Decrease the speed
or
Increase the speed
in
Once for 5
Min is 5
Once for 5
Max is 500*
Once for 25
Min is 50
Once for 25
Max is 500
(3) After adjusting the Pressure or Speed, press
or
4.3 Languages and Baud rate
to save the settings.
(1) Press
or
button goes to the interface
Language
Baud rate
or
Switching between Chinese
and English
or
Switching Between 38400
or
and 56000
16
    "