Page 15 of 49

achieved.
3.5 loading a sheet
Either a piece of sheet or a roll of sheet can be loaded on the plotter.
Figure 3-3
Figure 3-4
(1) Lift the lever to rise the pinch rollers. (see Figure 3-3)
(2) Load the sheet and slide to under the pinch rollers form either the front side or backside.
The alignment ruler on the platen will help you to adjust the sheet precisely.
(3) Slide the pinch rollers manually to the proper position. Be sure the pinch rollers must be
positioned above the steel axes. The red mark on the top trail will remind you where the
steel axes are.
(4) Press the lever to lower down the pinch rollers.(see Figure 3-4)
NOTE: If you want to cutting a sheet without a reversed adhesive paper (like a
pasteboard),You should use a sticker sheet under it.
CAUTION: Move the pinch roller by applying force at the rear portion of the pinch
roller support. Do not move it by holding its front rubber roller.
15
    "