Page 14 of 49

Figure 3-1
How to install a blade
Figure 3-2
(1) Remove the blade sheath by rotating it.
(2) insert the blade into the hole of the blade handle.
(3) Adjust the blade tip to suitable length by rotating the adjusting knob and blade sheath
clockwise or count-clockwise.
OK
The length of blade is not enough
The length of blade is too long
NOTE: The suitable length means the blade’s length is adjusted 0.1mm more than
film’s thickness and it can completely cut through the film layer yet avoid
penetrating the base paper.
3.4 Blade holder installation
Install the blade holder into the tool holder of the carriage, press the brim of the blade
holder against the tool holder.rotate the knob of the tool holder clockwise and surely fix it.
NOTE: Fix the tool holder firmly. If not, accurate and high-quality cutting will not be
14
    "