Shenzhen Reader Technology Co., Ltd
change accordingly.
9.2 User Parameters
(1) Cutting Parameters (Only affect cutting arts)
Idle Move Speed: this parameter decides the highest speed of all non-lighting
lines for the machine in the movement process.
Idle Move Acceleration: it means the highest acceleration of all non-lighting
lines. Idle stroke speed and idle stroke acceleration can be set higher to reduce
the working time of the whole figure, but if they are set too high, it may cause the
jarring of track, so comprehensive consideration should be given to the setting.
Turning Speed: it means the speed of turning at the acute-angle corner, which is
also the highest speed in the whole cutting process.
Turning Acceleration: it means the acceleration of turning at the acute-angle
corner when cutting. If the two speeds are set too high, jarring will happen to the
turning; if set too low, it will influence the cutting speed.
Cutting Acceleration: it means the highest acceleration value in the whole
cutting process.
Cutting Mode: it is divided into high-speed cutting and precision cutting. In
high-speed cutting, priority is given to the cutting speed, but in precision cutting,
the cutting effect.
Acceleration Mode: it is divided into T acceleration and S acceleration. T
accelerate will quicken the whole cutting process, but it will result in that its
cutting effect is inferior to that of S acceleration.
(2) Scanning Parameters (Only affect scanning arts)
X-axle Starting Speed
Y-axle Starting Speed
X-axle Acceleration
Y-axle Acceleration
The above four parameters are used to set the starting speed and acceleration of
two axles on the scanning. The higher the two speeds are, the quicker the scanning
is.
Scanning Line-feed Speed: this parameter is specially used to control the
highest speed at which that the previous line vertically moves to the next line in
the scanning mode. If the space between lines is larger during the scanning or if
the distance of each block is larger during the scanning and deblocking of figure,
it is necessary to position each line or block accurately. In such a case the speed
of scanning line-feed can be set as a lower value.
Scanning Mode: it is divided into general mode and special mode for option. If
special mode is used, the laser power should be increased. The smaller the
speckle percentage is, the more the laser power reduces. The laser power to set
40
