Laser Engraving & Cutting Control System Manual

5.5.3.5 Download processing file

Download the processing file to the controller and start the processing.

5.6 Making AI File

Cutting the AI Format usually works smoother and makes less mechanical strikes. Advisably, make use of the AI Format

File as much as possible, especially in the constant speed. Should there perhaps be some obvious strike when cutting at

varied speeds, and the figure is distorted, please change the file to PLT.

5.7 Backlash Adjustment in Engraving

When engraving at high speeds, a possible BURR. Please see below.

d

There is Backlash Compensation set in the Engrave Set of the Machine CFG. The backlash can be negative or positive

value. Change the engrave step to 2mm, backlash 1mm, and start processing. If d increases, change it to a negative value; if

d decreases, increase the number. Gradually d will near 0 after several adjustments. The value of the Backlash

Compensation differs from different speed; you should set it according to different speed ranges.

66