Laser Engraving & Cutting Control System Manual

5.2.4 Downloading The Job File

It is the same as the single machine operation.

5.3 Controlling Several Machine in One Software (In this case, several machines are connected to

the computer )

5.3.1 Wiring Diagram

When several machines are connected, ONLY the NET Mode is supported. The cable class is equal to or higher than the

Unshielded Twisted Pair (CAT5).

5.3.2 Setting IP Mode

Set the IP mode as AUTO in the supporting interface of the PAD panel.

5.3.3 Setting Machine ID

Set the machine’s ID in the supporting interface of the PAD panel. The TruCUT Laser Software will not allow the computer

to have the machine’s ID duplicated.

5.3.4 Identifying the Machine ID

Power the machines ON and run the TruCUT Laser Software. The software will acquire each machine’s IP address

automatically. The different ID numbers will be shown in the drop-down menu.

5.3.5 Machine Setting

Choose the machine ID you want to control, a CFG file will be generated accordingly. Input proper parameters and save,

then download to the controller.

5.3.6 Choose Machine ID and Download Data

Before proceeding with ‘DownLoad’, you should select the machine’s ID first.

61