Laser Engraving & Cutting Control System Manual

of the power and corner power can ensure an unchanged strength of the laser in the process).

Overlap Length: Closed graph may not to be cut down due to a mechanical error. This parameter helps to solve the

problem, but it should not be too large. This implies that a Mechanical Assemble Precision is needed to solve the problem.

Blow Mode:

Not Blow: Not to blow in the process.

Cut Blow: Blow when laser is on, and stop blowing when laser is off. This function needs hardware support.

Always blow: Blow immediately the laser head begins to move, and close at the end of the process. This function needs

hardware support.

Flying Cut: Select this option and the system will cut in a fast moving mode.

Flying Cut Mode:

Dotted Line: Cut the line to dotted line. 1,-1 describes the dotted line.

Jump for Fast: this mode can increase cutting efficiency and quality, but it’s only useful when the graph is being

processed by ‘Part Virtual Array’.

Layer Times: a layer can be processed many times. Log in your intended values.

Delay before laser on: Set the delay before the laser is on

Delay after laser on: Set the delay after the laser is on.

Delay before laser off: Set the delay before the laser is off.

Delay after laser off: Set the delay after the laser is off.

3.5.3 Setting Engraving Parameters

32