7. Step 7
Close all doors and press the "laser" button. Notice the mark that the laser makes on the
target. You should press the "Laser" button just enough times that the new mark reveals a
well-defined oval. The oval shape is because the mirror is at 45 degrees angle off of the
laser beam axis. The oval could be as small as 4,76mm or as large as 12,7mm. This
depends on the laser tube power. Don't be scared if you see a flash of light or flame. It
could be the paper vaporizing as it burns instantly from the laser heat. Make sure to
observe if the tape catches fire. (Quickly put out the fire and make sure all the mirrors are
clean.)
8. Step 8
Now the laser has been made on the tape target. Move the gantry closer to the front of the
machine.
9. Step 9
Place a small piece of masking tape over. This will allow you to see where the new laser
mark will be.
    "