RDWork Laser Engraving Cutting Software V1.3
Acc: Buttons move the axis motion acceleration value, cannot be higher than the maximum
acceleration.
Invert direction: Used to control the movement of the manual button when the mobile movement
axis direction.When set the right direction of polarity parameters, if press the direction key on the
operation panel, the axial direction, which buttons can reverse.
4.11.2 Laser parameters
Laser config: Single tube/pipe is optional, according to the number of laser tube manufacturers
actual configuration Settings.
Laser mode: Glass tube, radio frequency laser (don't need precombustion pulse) and radio
frequency laser (need precombustion pulse) optional.
Laser attenuation、Min power、Max power、Laser freq、Preginition freq:
Preginition pulse: For radio frequency (%) laser and precombustion pulse, frequency and
precombustion by precombustion pulse width configuration precombustion characteristics of the pulse.
Signal level:
Water protect: When can make water protection, the controller must be connected to water
protection circuit, the machine won't out of the light, if we do not make water to protect, don't pick up
the water protection circuit, the controller will not detect.
Laser frequency used by the control signal is used to set the laser pulse frequency, the glass tube,
generally set to about 20 KHZ, Radio frequency tube usually about 5 KHZ;Maximum/minimum power (%)
is used to set the limits of the laser power value, namely at runtime, users to set maximum power can not
be higher than the set value of maximum power, user Settings cannot under minimum power value for
the setting of the minimum power value;Use after a period of time, if the laser power attenuation, is by
setting the attenuation coefficient to fine-tuning of laser power, laser without attenuation, attenuation
coefficient of 0.
Prompt: If single laser tube is configured, it only shows a laser parameters.
4.11.3 Other vendor parameters
Machine type: For the most part should choose general engraving machine, other models for a
particular model
Transmission mode: Under normal circumstances should choose "step type belt", choose other
type, control algorithm will have small change
Feed mode: A one-way/two-way optional.When for one-way feeding, do not check the coordinate,
SHENZHEN RUIDA TECHNOLOGY
70
