RDWork Laser Engraving Cutting Software V1.3
Laser 1, laser 2: corresponding to the main board laser signals 1 and 2 of the way way laser output. If
it is only head machine, the second road laser meaningless.
The minimum power, the maximum power: the power of the values of the range of 0 to 100, said
that in the process of the strength of the laser processing; Big value, the laser is strong, is small, the laser
weak. Minimum power loss to the most power is less than or equal to.
For different processing type has a different meaning.
For cutting processing, the actual power is cutting speed and phase follow, speed, low energy is also
low, high speed is high also, so that we can guarantee the whole process of cutting energy evenly.So the
minimum power the speed of the corresponding minimum energy, the minimum speed general is 0, but if
set the speed is the minimum speed for takeoff take-off speed; The maximum power correspond to the
layer speed.
Set minimum power, and the most high power flow:
1> The minimum power and the maximum power set to the same value, synchronous adjustment.
Until all the cutting curve are already appear.
2> The maximum power unchanged, and gradually reduce the minimum power until the energy of
the heavy cutting curve at the lowest level, and all of the cohesion parts can be processed to come out.
3>If not yet to best effect, can be the most appropriate fine-tuning high power, and repeat step 2.
If is cut through, the minimum power loss and the maximum power no significant difference, can be
set to give the same.
To scan processing, ordinary scanning, the minimum power and the maximum power must be
consistent. Slope sculpture, minimum power loss is the power of the corresponding factors, the most
power is the power of the bottom of the corresponding.
to
p
bot
tom
Minimum power loss is the top for the small slant wide, detail place distinguish clearly.
Minimum power loss is too large slope not obvious.
To fix processing, the minimum power and the maximum power can be set to agree.
If checked "default", the actual power panel set by the power to determine.
Click the button "advanced", but also can be set to other layer parameters.
SHENZHEN RUIDA TECHNOLOGY
63
    "