RDWork Laser Engraving Cutting Software V1.3
After set feeding parametersthe shaft will be feeding a feeding length, and repeat the process , until
the times of processing reach to number of feeding.
If the machine is not equipped with feeding devices, in general, enable the feed ban.
4.9.3 Optimization of Backlash Compensation
When the machine there is space (such as dislocation of the seal cutting graphics), can be checked.
4.9.4 Optical 2 migration
In need laser collaborative work, complete the same graphics processing occasions, usually, to use
the optical 1 to define the graphics location, then if the optical 2 can accurately with the optical 1, will
need to specify the optical 2 relative to the optical 1 offset.
This generally used in two power different laser tubes of machine, because two of laser tube power
different, cause different functions.
If some machines equipped with two different power of laser tube, a responsible for cutting, a
responsible for sculpture.
4.10 Layer Settings
SHENZHEN RUIDA TECHNOLOGY
59
    "