3.3.1 Cut parameters
RDWork Laser Engraving Cutting Software V1.3
Idle speed: this parameter decides the max. speed of all lines not emitting beams during the
operation of the machine. This parameter should not be lower than the lower of the jump-off speed of
the X-axis and that of the Y-axis and not exceed the higher of the max. speed of the X-axis and that of the
Y-axis, if the setting is illegal, the controller will automatically set this parameter within the range above; a
comparatively high idling speed can shorten the operation time of the entire figure while excessively high
idling speed may cause dithering of the tracks, therefore, you should take all relevant factors into
consideration when setting.
Idle Acc: Corresponds to the acceleration of the speed of air travel time, air and air-way-way speed of
acceleration to match, if you set too slow the actual speed may not reach the air-way set value, if set too
fast, they may not withstand the mechanical structure, resulting jitter . Slightly higher than the general
acceleration of air-way cut acceleration.
Cutting Acc: Corresponding to the acceleration of the speed of cutting (cutting speed is the speed of
the layer parameters of the layers).
Acc factor:the corresponding coefficient of empty walking speed,the greater the ratio,the greater the
idle speed.
Go Acc factor:Corresponding coefficient of cutting speed,the bigger the ratio the greater the cutting
speed speed faction: Rount the corner turning speed,the greater the coefficient is larger.
Turning speed: Turning the corresponding deceleration in the cutting process, the minimum speed of
the drop, when processing a lot of teeth when the graphics may be appropriate to reduce the turning
speed.
Turning Acc: Should match with the turning velocity.
Cutting mode: Split precision cutting, fast cutting, ultra-fast cutting, the user can choose according to
the actual applications. Such as the emphasis on accuracy, select the precision cutting, such as
emphasizing speed, select the fast cutting.
SHENZHEN RUIDA TECHNOLOGY
47
    "