Page 40 of 68

RDVisionWorks Large format visual cutting software V1.0
Null speed: the highest speed of all non sculpted straight lines during the movement of a machine. If
the user sets the parameter illegally, the controller will automatically put it in the above range; if the airway
speed is set larger, the working time of the whole graph can be shortened, but the settings are too large,
which may cause the trajectory to shake. Move.
Airway acceleration: corresponds to the speed of acceleration when walking, airway acceleration and
airway speed to match, if set too slowly the actual airway speed may not reach the set value, if set too fast,
the mechanical structure may not be able to bear, resulting in jitter. The general acceleration is slightly
higher than the acceleration.
Turning speed: Corresponding to the lowest speed in the process of carving when turning down, when
there are a lot of sawtooth, the turning speed can be reduced appropriately.
Turning acceleration: it should match the turning speed.
Cutting acceleration: corresponds to the speed of cutting (cutting speed is the layer speed in the layer
parameters).
Idle time delay: when a machine is not sculpted, it needs waiting time before movement.
Acceleration ratio: the coefficient corresponding to the cutting speed, the greater the rate, the greater
the cutting speed.
Null acceleration ratio: the coefficient of velocity corresponding to the empty travel time, the greater
the rate, the greater the speed of the empty path.
SHENZHEN RUIDA TECHNOLOGY
34
    "