RDEMarkVision Operation Manual

parameter).

Idle time delay: when a machine is not sculpted, it needs waiting time before movement.

Acceleration ratio: the coefficient corresponding to the cutting speed, the greater the rate, the greater the

cutting speed.

Null acceleration ratio: the coefficient of velocity corresponding to the empty travel time, the greater the rate,

the greater the speed of the empty path.

Turning coefficient: the greater the turning speed, the greater the turning factor.

Feed parameters -

The delay before feeding: when the feeding device is used, the time is delayed before the single feed. Users

can arrange such processes as picking and picking up at this time.

Delay after feeding: it means that the feeding device will send the material to the place, and it needs to be

stabilized for a period of time before processing.

Line by line feeding: the feeding device sends materials one by one to the place in a way of feeding.

Progressive feed compensation: there may be some errors in the use of feeding devices for progressive feed.

Reset parameters --

Reset speed: when the machine is turned on, it will return to the original point. If the machine is larger, the

reset speed can be set, but not too large.

X, Y, Z, U boot reset: you can set up whether each single shaft is reset during boot.

Other

parameters -

Array processing mode: two way array and one way array can be selected. Two way array: cut the array in

sequence; one way array: cut the array from one direction to another. When one way array is chosen, the operation

mode of each array unit is exactly the same, and the action fluency is exactly the same, but it takes less time than

the bidirectional array. A two-way walk array is selected by default.

Location of return: mechanical origin, location and non return position. This parameter determines the

position where the carving head stops after each work.

Focal length: corresponding panel auto focus operation.

Reverse gap X, Y: used to compensate for the reverse gap caused by machine transmission.

Z axis parameter

Knife lifting position: the position of the cutter head when the machine starts carving.

Location of the cutter: the position of the cutter head when the machine is finished.

Docking position: the position of the carving head after machine carving.

Cutting speed: the speed of the cutting head of the carving head when the machine is engraving.

Pre processing delay: waiting time before machining.

3.5 information

Click the information and pop-up the information dialog box as follows:

RuiDa Technology

1TH FLOOR,5TH BUILDING,NANYOU

TIANAN INDUSTRIAL ZONE,SHENZHEN

Phone: (086)0755-26066687

19

E-Mail: support@rd-acs.com

Web: www.rd-acs.com

FAX: 0755-2698287