3.4用户参数

点击用户参数，弹出用户参数对话框，如下图：

RDEMarkVision Operation Manual

3.4 user parameters

Click on the user parameters to display the user preferences dialog box.：

Origin location: this setting is mainly for single head machines. The setting of the origin must be consistent

with the actual origin of the machine.

Small circle speed limit: when cutting small circle, it will be cut at the specified speed.

Feeding settings: after carving, feeding can be carried out to achieve continuous automatic processing.

Before the operation of user parameters, the motherboard parameters must be read.

Null speed: the highest speed of all non sculpted straight lines during the movement of a machine. The

minimum can not be less than the X/Y shaft take-off speed of the small person, the maximum speed can not

exceed the maximum speed of the two axes, if the user setting is illegal, the controller will automatically put this

parameter in the above range; the space speed setting is larger, can shorten the working time of the whole figure,

but the setting too large may cause the trajectory to shake. Move.

Air distance acceleration: the acceleration and slow speed corresponding to the air travel time, the air

distance acceleration to match the air distance speed, if the set too slow actual space speed may not reach the set

value, if set too fast, the mechanical structure may not bear, and cause jitter. The general air range acceleration is

slightly higher than the carvings acceleration.

Turning speed: corresponding to the minimum speed of falling speed during the carving process, when the

machining pattern has many sawtooth, the turning speed can be reduced properly.

Turning acceleration: it should match the turning speed.

Cutting acceleration: corresponds to the acceleration speed of cutting (cutting speed is layer speed in layer

RuiDa Technology

1TH FLOOR,5TH BUILDING,NANYOU

TIANAN INDUSTRIAL ZONE,SHENZHEN

Phone: (086)0755-26066687

18

E-Mail: support@rd-acs.com

Web: www.rd-acs.com

FAX: 0755-2698287