RDEMarkVision Operation Manual

be back in results interface. You can know the mark point elated parameters from test results.

3.2.3 Enable Secondary Positioning

After searching the target, not set this location coordinates as criterion, but moved to the target automatically,

take photos again, and repositioned target location coordinates.

Distance offset / Angle offset: When two-point positioning, such as you might find more features when

searching feature 2, according to the distance between feature 1 to feature 2, if found multiple features in the

circle arc of feature 1 as origin, then as angle to distinguish them.

Note: But when the offset is set too small, missing cut will be happened. Generally distance offset can be set

within 2mm, angle offset within 5°, such as the workpiece requires more accurately, you can set smaller.

3.2模板参数设置

3.3 output setting

Layer parameters: set the layer cutting sequence, speed and power.

Optimization of road strength: setting the graphic output path.

Block processing: select the height of the graph and cut the partition area.

RuiDa Technology

1TH FLOOR,5TH BUILDING,NANYOU

TIANAN INDUSTRIAL ZONE,SHENZHEN

Phone: (086)0755-26066687

17

E-Mail: support@rd-acs.com

Web: www.rd-acs.com

FAX: 0755-2698287