RDC6685U(-DFM) Control System manual

 After-feeding Time Lag: settable at 0~9.9s. It can facilitate the feeding device’s

delaying in jarring after moving to the correct position and waiting for the 2nd work after the

feeding axle stands still completely.

 Last feeding: If feeding when the last times work end.

（3）Reset parameters

 X1/Y1 Reset Speed: it means the speed of X1/Y1-axle linkage reset to the origin

 X2/Y2 Reset Speed: it means the speed of X2/Y2-axle linkage reset to the origin

 Z1 Reset Speed:

 Z2 Reset Speed:

 U1 Reset Speed:

 U2 Reset Speed:

The above four parameters are used to set the single axis reset speed of Z1/Z2/U1/U2

respectively。

 X1/Y1/Z1/U1/X2/Y2/Z2/U2 axle start-up reset(Auto home)

You can select “Yes” or “No” in the field of the above eight parameters, which is used to confirm

whether each axle can be reset on the startup.

（4）Go scale parameters

 Go scale Mode: “Blanked Bordering” means idling to start border preview; “Outputted

Border Cutting” can manually cut off the well-processed figure; “4-corner Dotting” means to

emit the light at four corner points of the frame to make a point and turn off light. The size and

position of this figure can be checked intuitively through the four points. The bordering speed is

the speed value set on the keyboard when the system is idle. For light output, its

minimum/maximum power is the corresponding value set on the keyboard when the system is

idle (The lasering power on the 4-corner dotting means the well-set maximum power).

 Go scale Blank: It means whether to extend a certain length outside the actual frame

of the figure on the preview/cutting of frame.

If the frame crosses the border, the interface will prompt it. If the Enter

key is pressed at this time, the system will cut the border at the

Prompt maximum/minimum coordinates first, and then border the figure. This

bordering can be given up.

（5）Other user parameters

SHENZHEN RUIDA TECHNOLOGY

67