RDC6685U(-DFM) Control System manual

Figure

8.5.2-4

Figure

8.5.2-4

The operation and settings of the factory parameters are the same as the user parameters.

8.5.3 Origin Setting

In the menu interface, select "Origin setting" entry and press the <Enter> key ,it will show as

below:

Figure

8.5.3-1

At this point, the "blue selection block" defaults to select the "Mult origin enable" entry, press

the <Enter> key to enable or disable(the right small square shows red when enabled), when enabled,

the little finger to "Origin 1 enable" entry means to start setting the origin point 1, first move the

"blue selection block" to this entry and press the <Enter> key to enable the location point 1 entry,

then press <Shift> key, then press the direction key to change the X/Y axis coordinate value, then

press <Origin> key to set the current coordinate value to the location point 1, and finally press

<Shift> key to return to the current interface operation. The operation process interface is as follows:

SHENZHEN RUIDA TECHNOLOGY

42