RDC6685U(-DFM) Control System manual

8.4 Set the layer parameters

After selecting a file to preview on the main interface, If there is layer information in the layer

parameter area, show as below:

Figure

8.4-1

User can push <Enter> key to let the cursor move to the first layer show as below:

Figure

8.4-2

And then “Up and down” Keys can be pushed to select the intent layer, on that time, user can

push <Enter> key to check the selected layer’s parameters, show as below:

Figure

8.4-3

At this point, the "blue selection block" stays on the layer number entry, and then press the

<Enter> key to enter the selection layer mode, while the "blue selection block" becomes , press

the "up/down" key to select other layers, and then press the <Enter> key to exit the layer selection

mode. Then press the "up/down" key to move the "selection block" to the layer parameter entry to

be modified. Press the number key and the backspace key to set and modify the parameters. After

setting the parameters, move the "selection block" to the "write parameters" entry. Press the

<Enter> key to save the current layer parameters, otherwise the parameters will not be saved. Press

SHENZHEN RUIDA TECHNOLOGY

37