User’s Manual of RDC644XG Control System

Figure 8.3-5

Push “Z/U” key to move the green block to the anticipant item, and when the green block is on

“enable” items, push “Enter” key to enable or disable the item, when enabled, the small

diamonds is green, and when disabled, the small diamonds is grey. When the green block is on

the “Set origin” item or the “Next origin” item, push the “X+-“ keys to select the value.

Pay attention to if when the green block is on the “Set origin” item, push the “X+-“ keys to select a

value, then, “Enter” key must be pushed to valid the change, or, the change is invalid.

Each item introduced as below:

 Multiple Origins Enable: “Yes” or “No” can be selected. If you select “No”, the

system will use the single-origin logic. You can press the “Origin” key and set the origin,

and only this origin can become valid. If you select “Yes”, the system will use the

multiple- origin logic and the “Origin” key on the keyboard become invalid. In such a

case, the parameter of each origin must be set in the menu as follows.

 Origin Enable1/2/3/4: after the multiple-origin logic is enabled, the four origins

can independently be prohibited and enabled.

 Set Origin 1/2/3/4: after the multiple- origin logic is enabled, you can stop the

cursor at “Set as Origin 1/2/3/4”. Press the “Enter” key on the keyboard and the system

will take the coordinate figures of current X/Y axles as the corresponding ones to the

origin 1/2/3/4.

 Next Origin: there are such five digits as 0~4 for option, which are the origins to be

used for the next figure. Origin 0 means the origin set by the “Origin” key on the panel

in the single- origin logic. 1~4 means the serial number of the origins in the multiple-

SHENZHEN RUIDA TECHNOLOGY

39