User’s Manual of RDC644XG Control System

User can push “Z/U” Keys to move the green block on the intent parameter, then he could change

the parameter if needed. “OK” to validate the change, and “Esc” to invalidate the change.

8.3 Z/U Key

The Z/U key can be pressed when the system is idle or the work is finished. On pressing this key,

it will show some entries in the following interface:

Figure 8.3-1

Push “Y+/-” keys to move the green block to the anticipant item, and then push the “Enter” key to

display the sub menu.

8.3.1 Z move

When the green block is on “Z Move” item, “X+/-” keys can be used to move the z axes.

8.3.2 U move

When the green block is on “U Move” item, “X+/-” keys can be used to move the u axes.

8.3.3 Axis reset

When the green block is on this item, push the “Enter” key to show as below:

SHENZHEN RUIDA TECHNOLOGY

36