RDC6445G/S Control System manual

Manual mode has “Continue” and “Manual”, press the <Enter> key to enter the modification

mode ("blue selection block" right side becomes ), press the "up/down" key to modify, after the

modification, press the <Enter> key to exit the modification mode. After all modifications, move the

“Select block” to the Write Parameters entry and press the <Enter> key. The parameter settings take

effect. Press <Esc> key to return to the previous menu.

When “Continue” item is selected, then the “Manual” item is not valid, on that time, push the

direction keys to move the corresponding axes, and when the pushed key is loosed, then the

corresponding axes will finish moving. When the Mode item is “manual”, then pushing the direction

key one time, the corresponding axes will move a fixed length, unless the scope is overstepped.

8.7.4 Laser Setting

Select the "Laser setting" entry under the funtions interface, press the <Enter> button, and then

pop up the interface as follows:

Figure

8.7.4

The operation method is the same as manual setting.

When “Continue” item is selected, then the “Laser time” item is not valid, on that time, push the

Laser key to splash the enabled lasers, and when Laser key is loosed, then the lasers will finish

splashing. When the Laser mode item is “Manual”, then pushing the Laser key one time, the enabled

lasers will splash a fixed time.

SHENZHEN RUIDA TECHNOLOGY

48