二、 Lift parameter setting:

The height of processed materials is consistent (using a single lift): When only one lift is required during

the entire processing process, enable a single lift in the user parameters, and then set the offset height of the

single lift.

After starting processing, the Z axis will check whether the current position is safe. Then the XY axis moves

to the processing starting point (②), and the Z axis moves to the processing position (③), and starts processing

after reaching the position (④). After the processing is completed, the Z axis moves up to the stop point (⑤), as

shown in Figure 1:

①

②

⑤

Z轴停靠点

③

④

激光焦点+单次抬落偏移高度

加工物料

台面

The height of processed materials is inconsistent: Use the control method of layer lifting to distinguish

different heights by layer. Set the relative offset height separately according to the process requirements, and

then use the teaching function to adjust the lifting position of this processing layer. After the last processing is

completed, the Z axis will move to the position of the stop point of the Z axis.

(Pay attention to the rationality of the parameters, and try to avoid the unreasonable setting of the lifting

position after the processing of the previous layer is completed, which may cause collision during the idle

movement.)

Web：www.rd-acs.com | TEL/FAX：0755-26066687/26982287 64

202-203, B-Block,Technology Building, 1057 Nanhai Avenue,Nanshan District,, SHENZHEN, CHINA