coordinate system and an absolute coordinate system in the software.

Figure: Coordinate system selection

Floating coordinate system: In this coordinate system, the positioning method used is processing at the

current position. That is, according to the current position of the laser head and the positioning point of the

processed graphic (the small green square next to the graphic), the graphic is moved to the current position for

processing. In this coordinate system, the positioning point of the graph should be appropriately set. If the

positioning point setting (can be set in the user parameters) is not appropriate, it may cause the graphics to

exceed the processing area after moving. For example: the laser head is currently located at the lower left corner

of the breadth, and the graphic positioning point is set at the upper right corner of the graphic, then when the

processing starts, the graphic will move beyond the breadth.

Absolute coordinate system: In this coordinate system, the position of the graphics is unchanged during

processing, and the laser head moves to the position of the graphics to start processing. Generally, absolute

coordinate system processing is used.

Manual movement:

Figure: Manual movement

Manual movement is mainly used for single axis movement to control the axis to move in up, down, left and

right four directions. The single axis movement can be continuous or stepping. Continuous movement is to press

and hold one of the up, down, left and right buttons, then it will keep moving in that direction; Inching

Web：www.rd-acs.com | TEL/FAX：0755-26066687/26982287 61

202-203, B-Block,Technology Building, 1057 Nanhai Avenue,Nanshan District,, SHENZHEN, CHINA