Layer lift

Scan

Min, max power

Cut freq

Power ratio

On delay

Off delay

Linkage IO output

Lift control enable

Enable primitive lift

Rise position

Offset height

Overcut

Scan mode

Bitmap processing

Scan space

Out by curve

filling method to process the closed metadata to this layer

before outputting. Bitmap cutting is to cut the outer frame of

the bitmap, and scanning is to output the scanned image data

after processing according to the processing method.

The power value ranges from 0 to 100, which indicates the

strength of the laser during processing; The value is large, the

laser is strong, and the value is small, the laser is weak; The

minimum power should be less than or equal to the maximum

power. When scanning, set the maximum and minimum power

to be the same. In FSP mode, only the maximum power is valid.

In PSV mode, the maximum power and minimum power need

to be adjusted.

When processing corresponding primitives, control the

frequency of the PWM signal output by the laser.

。

Valid in FSP mode for micro pulse processing. Generally, the RF

tube cutting is set to 100%.

When processing graphics, delay the opening time to prevent

the starting point from over burning due to the motion lag.

Delay the time of turning off the laser to prevent the cutting

pattern from not closing due to the motion lag.

When processing the data of this layer, the checked IO also

outputs a low-voltage signal, which can be connected to the

external equipment that needs to distinguish the layer for

related process processing.

After checking, this layer will execute automatic lifting action

during processing

After checking, each primitive will perform a lifting after

processing

When the motor is used to control the Z axis up and down, the

coordinate position that the Z axis will rise automatically when

cut this layer

When the motor is used to control the Z axis up and down, the

distance between the laser focus and the cutting table when

processing this layer

In the case that the effect of delaying the laser-off is not work,

repeat the processing of a motion trail of the starting position

on the output metadata.

Vector and bitmap can generate scan lines in horizontal one-

way, two-way scanning and vertical one-way and two-way

scanning.

The bitmap processing method supports three types: black-and-

white image, dot image, and hanging network processing.

Sampling interval when generating scan data.

When the primitives of the same layer are scanned and

calculated, they are output as a single primitive or calculated

and output together with the layer data. Checking means a

single primitive output. Bitmap and vector graphics are

calculated separately.

Web：www.rd-acs.com | TEL/FAX：0755-26066687/26982287 59

202-203, B-Block,Technology Building, 1057 Nanhai Avenue,Nanshan District,, SHENZHEN, CHINA