Frame/Return

Engraving

Other

parameters

U axis power-on

reset enable

Return position

Stop point X

coordinate

Stop point Y

coordinate

Frame mode

Frame distance

Frame speed

X, Y axis start

speed

X, Y axis

acceleration

Line feed speed

Scan ratio

Blowing Type

Absorb Type

Absorb on delay

automatically reset when the machine is turned on, otherwise it

will not be automatically reset.

If the U axis power-on reset is enabled, the U axis will be

automatically reset when the machine is turned on, otherwise it

will not be automatically reset.

The position where the cutting head stops after processing.

There are four types of zero origin, original, non-return, and dock

position

It is used to set the X-axis coordinate position of the stop point.

It is used to set the X-axis coordinate position of the stop point.

The motion mode when the panel start to frame, it can be frame

with laser on or no laser.

The extension distance of the moving track of the frame relative

to the actual graphics frame.

The maximum speed of frame movement

The start speed of scanning, when the motor is used for

dragging, it is not necessary to start acceleration from 0, but can

directly start from a certain speed to shorten the overall

processing time, but the speed cannot be too high.

To match the scanning speed (the layer speed in the layer

parameters). if the setting is too small, the scanning will require a

longer acceleration distance, which will affect the scanning

efficiency. The actual setting varies according to the machine

structure and load condition.

This parameter is specially used to control the maximum speed

of vertical movement from the previous line to the next line in

the scanning mode. If the line-to-line spacing is large during

scanning, or the distance between each block is large when

scanning block graphics, and each line or block needs to be

accurately positioned, user can set the scan line feed speed to a

lower value.

It is equivalent to the acceleration in S-type, which indicates the

degree of urgency of acceleration and deceleration.

Set the blowing interface control mode, with manual blowing,

work, laser on blowing.

Adsorption control mode supports manual and automatic control

Used for automatic absorption, the system will start processing

after a period of time after opening the adsorption

Web：www.rd-acs.com | TEL/FAX：0755-26066687/26982287 56

202-203, B-Block,Technology Building, 1057 Nanhai Avenue,Nanshan District,, SHENZHEN, CHINA