Laser source

Whether to enable the laser source control, if it is not enabled,

Laser source enable the laser source cannot be controlled.

Different types of laser sources have different control signals, so

Laser source type you need to select the correct laser source type.

Support PSS, PSV, PSP, FSP mode optional. PSS is a fixed power

Control mode

mode, PSV is a power following mode, PSP is a position

synchronization mode, FSP is a fixed pulse width mode, and the

default is FSP mode.

Processing signal

effective

Laser frequency

Maximum power

First pulse

suppression

starting power

Set the PWM control signal effective level

Set the PWM working frequency

Maximum allowable output power

Taking the RF tube as an example, if the same signal is used to

control the laser on, the first few pulses actually output by the

laser source have a large energy, so it needs to be suppressed.

First pulse

suppression

duration

Enable pre-

combustion

The first pulse suppression time, beyond this time, the normal

laser control signal will be output

Some RF tubes need to have a pre-combustion signal, and

parameter is used to output a pre-combustion signal.

Pre-combustion

frequency

Some RF tubes need to have a pre-combustion signal, and

parameter is used to set the pre-combustion signal frequency

Pre-combustion

pulse width

Some RF tubes need to have a pre-combustion signal, and

parameter is used to set the pre-combustion signal duty cycle

Step distance measurement method: Manual to move 100mm in a single direction to measure the actual

movement distance. Then click the button to enter the calculation interface, fill in the value set at the

beginning and the measured value, and click OK to calculate the equivalent. You can also cut a relatively large

rectangle, and then measure the size of the cut graphics and compare with the size set by the software.

Web：www.rd-acs.com | TEL/FAX：0755-26066687/26982287 52

202-203, B-Block,Technology Building, 1057 Nanhai Avenue,Nanshan District,, SHENZHEN, CHINA