Z axis

configuration

Power-off delay

Y axis origin

position

Software testing

the laser

Enable permission

protection

Enable Z axis auto

lifting

Control mode

Control object

Z axis origin

position

modifying the positive and negative values of the feeding length.

0~3000ms can be set. After the power grid is cut off, the system

power supply will not drop to 0V immediately, during which

there is a delay. The delay value set here should be basically the

same as the actual power-off delay value. If the deviation of the

setting value is large, when the power is cut off and the

engraving is continued, the processed graphics and the graphics

before the power failure are either not closed or overlapped too

much.

It is applied to Y axis pressing material, select whether the

pressing material is above or below.

This option is used in conjunction with Mark point vision. Check

it to control the brightness of the light source through the serial

port.

After enabling the permission protection, from "CNC" ->

"Permission Management" to perform hierarchical authority

management for each function of the software, and the

corresponding operations can only be obtained by modifying it

to the corresponding authority level.

The system will execute the Z axis automatic lifting control only

after the enable is checked. If the Z axis automatic lifting function

is disabled, all Z axis lifting and lowering actions are invalid, and

the Z axis movement is only controlled by manual movement.

It is used to describe the actual configuration of Z axis of the

equipment, and support motor control and cylinder control. Use

card Z axis control interface when selecting the motor mode, and

use card OUT1 interface when selecting the cylinder mode.

It is used to describe the actual configuration of the Z axis of the

equipment, and control whether the cutting head moves or the

platform moves.

It is used to describe the actual configuration of the Z axis of the

equipment. When the Z axis is reset, the control object is to

move up to reset or move down to reset.

Web：www.rd-acs.com | TEL/FAX：0755-26066687/26982287 51

202-203, B-Block,Technology Building, 1057 Nanhai Avenue,Nanshan District,, SHENZHEN, CHINA