Sealing processing:

Including sealing, notching, and over-cutting. Sealing is to seal and close the graphics with notches or over-

cut operations; Notching is the treatment of cutting off a section of the closed figure at the last position; Over-

cutting is to overcut the closed figure for a certain distance.

Figure: setting interface for notch and over-cut size

Circular cutting:

In order to prevent the speed from reducing too severely in the sharp corners and resulting in burnt corners,

a curve is added in the sharp corners to go around and cut to achieve the purpose of reducing the speed down.

Maximum included angle: Only when the angle is smaller than this angle can the circular cutting effect is

added.

Shortest side length: The length of the two sides forming the angle cannot be less than this value.

External length: the length of the extended circular cutting.

Automatic, external, internal, internal and external cutting: whether the circular cutting acts on the convex

corners or concave corners.

Cancel circular cutting: It is to eliminate the circular cutting of curve with circular cutting.

Fillet: After setting the radius of the rounded angle, enter the fillet state, click the vertex of the included

Web：www.rd-acs.com | TEL/FAX：0755-26066687/26982287 34

202-203, B-Block,Technology Building, 1057 Nanhai Avenue,Nanshan District,, SHENZHEN, CHINA