neffective when the special mode is selected this parameter (Page 49 / 51) RDC644XG Laser Controller User Manual

RDC644XG Controller User Manual

ineffective; when the special mode is selected, this parameter will become effective. The controller will

control this parameter among 50%~99%.

Prompt

The cutting and scanning parameters can’t exceed the limited ones in the axle

parameters. If so, the setting will become ineffective and the system will

automatically cover the parameters with the axis parameters.

(3) Feeding parameters

Before-feeding delay: can be set 0~300s, the upper axis will be moved after the last processing finished

and delay this item. It is convenient for the user feeding and select during the delay.

After-feeding delay: settable at 0~9.9s. It can facilitate the feeding device’s delaying vibrated after

moving to the correct position and waiting for the 2nd work after the feeding axle stands still completely.

If feeding line-by-line: if enabled feeding line-by-line function, the virtual array graphics on Y direction

will be processed in the same position.

Line-by-line feeding backlash: You can compensate the feeding length due to the inaccuracy for feeding

axis moving.

(4) Reset Parameters

Reset Speed: it means the speed of X/Y-axle linkage reset to the origin.

X- axis Startup Reset

Y- axis Startup Reset

Z- axis Startup Reset

U- axis Startup Reset

You can select “Yes” or “No” in the field of the above four parameters, which is used to

confirm whether each axis can be reset on the startup.

(5) Frame Setting

Frame Mode: “Blanked Bordering” means idling to start border preview; “Outputted Border Cutting”

can manually cut off the well-processed figure; “4-corner Dotting” means to emit the light at four corner

points of the frame to make a point and turn off light. The size and position of this figure can be checked

intuitively through the four points. The bordering speed is the speed value set on the keyboard when the

system is idle. For light output, its minimum/maximum power is the corresponding value set on the

keyboard when the system is idle (The laser power on the 4-corner dotting means the well-set maximum

49 / 51