RDC644XG Controller User Manual 834 Manual set+ When (Page 34 / 51) RDC644XG Laser Controller User Manual

RDC644XG Controller User Manual

8.3.4 Manual set+

When the green block is on this item, push the “Enter” key to show as below:

Figure 8.3-3

Push “Z/U” key to move the green block, and when the green block is on the “Mode” item, push

“X+-“ keys to select the anticipant value, “Continue” or “Manual”. When “Continue” item is selected,

then the “Manual” item is not valid, on that time, push the direction keys to move the corresponding axes,

and when the pushed key is loosed, then the corresponding axes will finish moving. When the Mode item

is “manual”, then pushing the direction key one time, the corresponding axes will move a fixed length,

unless the scope is overstepped.

8.3.5 Laser set+

When the green block is on this item, push the “Enter” key to show as below:

Figure 8.3-4

34 / 51