When the laser is the RF laser this pin will be connected (Page 19 / 51) RDC644XG Laser Controller User Manual

RDC644XG Controller User Manual

1. When the laser is the RF laser, this pin will be connected with

the laser RF-PWM end;

2. When the laser is a glass tube, this pin will be connected with

the laser power PWM end and used to control the power of the

laser.

WP1

The input port of water protector for the first laser power source.

When the water protector 1 is enabled, the controller will detect

the input port of water protector 1. If this port is of low level, it

will be deemed normal; if this port is of high level, the controller

will forcibly close the laser to suspend the work in progress and

the system will warn. If the water protector 1 is not enabled, the

controller will not detect the input port of water protector 1 and so

the water protector 1 can be unconnected.

Water protection input must be 24V logic level.

L-AN1

The analog signals for Laser Power. If Glass Tube is used, this pin

is recommended to control the power of the Laser.

Please correctly select the laser type in the factory parameters.

Prompt

19 / 51