4 Interface Signal of Controller 41 Interface of Main (Page 15 / 51) RDC644XG Laser Controller User Manual

RDC644XG Controller User Manual

Chapter 4 Interface Signal of Controller

4.1 Interface of Main Power Source CN0

Pin Symbols

Definitions

GND

24V power ground (input)

+24V

24V power positive (input)

Caution

This control system employs single 24 power supply. For a certain margin, it is

suggested to select 24V/2A above power. Besides, this system is compatible

with 36V power, that is to say, the 36V power of Motion driver can directly be

connected to this main power port of this system, but generally it is not

suggested to do so.

4.2 Controller-display panel Interface HMI

The connecting wire is parallel line of pin-to-pin.

4.3 Udisk Interface

Udisk is a USB-AM interface; the controller visits the u-disk by this interface.

4.4 PC-USB Interface

PC-USB is a USB-BM interface. The controller may communicate with PC by this port.

4.5 Ethernet Interface

Using this interface, the controller can communicate with PC by 10/100MHZ Ethernet.

Pin to Pin Ethernet parallel line is recommended.

Caution

15 / 51