LFS-PM-T43 operating manual
Cutting gas
X
Auxiliary gas selection for cutting
Rise posi
The rising height for laser head during jump motion
Alarm posi
When the alarm triggered, the laser head is on the stop
height
Stdby posi
When the cutting task is finished, the laser head is on the
position.
Height
Focus posi
Reset posi
The distance between the nozzle and the work piece
When reset the laser head, the laser head will trigger the
limit switch and move reversely for this distance
During a close control, the error between the actual position
Follow error
and referenced poison should never beyond the value. If that
happened, system protection will be executed and generate
the alarm of following error over limit
SPEED
machine
Rising spd
Tracing spd
Reset spd
fast
slow
polarity
acc
Screw pitch
resolution
Other
parameters
Reset En
Rising speed
The maximum tracing speed
Laser head reset speed
The manual fast speed
The manual slow speed
Set the rotation of the motor
Motion acceleration
Screw pitch
When the motor rotate one round, the number of control pulse
should sent to the motor drive
Enable or disable the reset when power on
If the crash alarm is enabled, when the laser head has touched
the work piece for a certain time(over the filter time), system
Crash En
will rise up the laser head and stop the motion of the cutting
Lmt SNS
system
If it is disabled, the crash alarm will be neglected.
Set the sense of the limit switch. If a NPN limit switch is
installed, user should set the polarity to be negative. If it is
    "